For part of my build I am installing a full float rear axle on my '84 fj60. I picked up a LSD a little while back and decided to go ahead and throw it in. I pulled the semi-float third and disassembled it so I could re-use the ring and pinion. I heated the ring up and slipped it on the diff. and bolted it up, no problems thus far. I was looking at the parts that came off of the semi float and I ran into a little confusion as to what needs/can be reused when I put it all back together. Basically the pin bolt that locks the cross shaft in on the semi-float does not fit the housing on the LSD: (pin circled in red)
Looking at the parts manual for the LSD, I am not sure if there is a different pin that goes in this space. Possibly this guy:
This is my first time taking apart a third so please bear with me, I'm learning as I go.
-Bahndo
Looking at the parts manual for the LSD, I am not sure if there is a different pin that goes in this space. Possibly this guy:
This is my first time taking apart a third so please bear with me, I'm learning as I go.
-Bahndo