Okay, I'm cusing along doing my front axle this morning, and have it all apart and cleaned up. Go to put in the upper knuckle bearing race, and lo and behold, I've seated it fully UPSIDE DOWN. The two little half-moon indents used to drift the old one out are quite flush with the race surface, so I can't just push it out again.
I've thouht of using a dremmel to increase the depth of the half-moon's slightly, but I don't want to do anything that's going to ruin the axle.
Any thoughts? Am I the only moron ever to have done this? :'(
I've thouht of using a dremmel to increase the depth of the half-moon's slightly, but I don't want to do anything that's going to ruin the axle.
Any thoughts? Am I the only moron ever to have done this? :'(