For those that have re-foamed and covered their jump seats…. (5 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

sleepycruiser

I will get by….I will survive -Touch of Grey LC200
Joined
Aug 20, 2016
Threads
246
Messages
3,752
Location
Asheville, North Carolina
I’m in the process of refoaming and putting the CC rear covers on my jump seats….do you cut the foam to sit ‘inside’ the outer tubes, or should the foam be cut to sit ‘on’ top of the seat tubes??

image.webp
 
Last edited:
Its two pcs glued together.
One in, one over

Also, jump seats...the bench is the front seats.

20250604_183209.webp
 
Last edited:
Ah gotcha. So each piece is 1” or each piece is 2”,
Its two pcs glued together.
One in, one over

Also, jump seats...the bench is the front seats.

View attachment 3967190
Ah gotcha. Is each piece you are showing 1” or 2” thick? I bought 2” foam.
 
Make a video of recovering the other seat :)
I’ll take a bunch of pics and post what I did, with links, in my build thread that is in my signature. I’m not very good at videos. :)
 
Needing to do my rear seats also.I'm going to tack the nut for the rubber bumps so if loosen will be able to tighten with out having to remove cover to use back up wrench.
I'm thinking about using a memory foam mattress topper to cut them out of and use as many thickness as needed, anyone try this?
 

Users who are viewing this thread

Back
Top Bottom