I'm trying to clean up bonded up holes for the rear view mirrors and was hoping to tap them, so I didn't want to screw it up ( pun intended)
Anyone know the diameter and thread width? The bolt number is 93239-15012, which states
Tensile strength of 1T
50mm diameter
12mm length.
I have to believe this isn't 50 mm in diameter. Is it safe to assume that it should be 5mm diameter?
Anyone know the diameter and thread width? The bolt number is 93239-15012, which states
Tensile strength of 1T
50mm diameter
12mm length.
I have to believe this isn't 50 mm in diameter. Is it safe to assume that it should be 5mm diameter?