F engine oil brass nut going to head (1 Viewer)

[Luis peralta]

Hi I’m looking to buy the two compression fitting nuts that go from the block to the head. I lost mine and can’t find a place where buy, I already looked in SOR but they only have the pipe and ferrules. Also order some from McMaster but they don’t fit, according to my measurement they are M10x1.25, pipe is 5 mm

 

[pjohnson]

Try belmetric.com

 

[73FJ40]

@Luis peralta

You should double check the pitch on your compression nuts.

The Parker web catalog shows M10x1 as a standard for 5mm tubing. Of course, if OEM is some Japanese standard, your 1.25 pitch would be correct.

https://ph.parker.com/ca/en/complementary-brass-fittings-reducers-olives-and-nuts

 

[martymart]

If you have the Toyota part number try Amayama Trading Co Ltd.