Electric hub removal

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Jul 6, 2006
I've pulled the 6 torx studs out, but the four studs remain.

Anyone know how to get these out, I don't understand how these studs work. :idea:

Trying to install my hub conversions, please help if you can
The six torx bolts only hold the outter cover on. It's about 1/2" thick. You might have to give it a tap. then once that cover is off you need to removed the 4 stud nuts. Then there are still cone washers that you need to remove. They are sticky so you need to tap the end of the studs with a brass drift or something hard but won't damage the threads. they will pop out when loose. Pull the snap ring on the end of the shaft then remove.
so just give those last four studs a good smack, and there out hey.

I don't think I have to worry about those threads, I'm fairly sure I don't need them as I will be running Warn hubs and RADD cruisers hub adapter.

Users who are viewing this thread

Top Bottom