Ok fellas' who makes the best functioning electronic ignition system for a 1971 1F motor?
Elecronic ignition
- Thread starter Barry Hofmann
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Yep.
Use the coil, ignitor, distributor and pushrod cover out of any FJ60. All you have to do is extend the dist-coil harness (two wires), and connect the ign wire that currently powers the ballast resistor to the coil.
Use the coil, ignitor, distributor and pushrod cover out of any FJ60. All you have to do is extend the dist-coil harness (two wires), and connect the ign wire that currently powers the ballast resistor to the coil.
I vote for the pertronix setup. Cheap, reliable and easy to get. Only takes two wires. Direct bolt in on pre 1975 distirbutors. After 1975, distributor needs to be swapped out for an older one.
