E&E Low Profile Bumper! (5 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Glad you had a good time in Moab!

These were designed for 2000lbs on the weakest area.
1745887165007.png
 
Bumper passed the bump test. Hells Revenge and Top of the world in Moab back to back and this is the only damage.
As one of the few people running AHC with this bumper, did you have to make larger cuts for it to account for low mode? My understanding is this bumper attaches to the frame while the body moves independently. Just trying to plan ahead appropriately.
 
Not sure what you mean? Other than about a 1/2 inch gap between the bumper and the plastic I don't see how it's any different than standard suspension. The AHC pump is frame mounted as well.
 
Not sure what you mean? Other than about a 1/2 inch gap between the bumper and the plastic I don't see how it's any different than standard suspension. The AHC pump is frame mounted as well.
I may have fumbled my words here. I apologize for any confusion.

When using AHC to raise and lower the car, does the new low profile bumper move with the rest of the body as it goes up/down? Or does the bumper stay in a fixed position?

My understanding is the bumper would be fixed while the body of the car would go up and down. Meaning if I put the car in low mode, the paneling could hit the fixed bumper? I could be over thinking it, just trying to mentally prepare
 
Last edited:

Users who are viewing this thread

Back
Top Bottom