Diff Drop Kit Group Buy

[BulletHead]

Thx Willy.


I'm getting these shipped much slower than I expected to but with the holiday season and sitting on the back burner with the machine shop, I'm hoping to get the rest out by end of Jan.

 

[MScruiser]

I got mine installed too.

One thing I would like to add though in regards to the instructions:

In the dialogue in step 5, it states:

...new 150mm Bolts through rubber shock mount with Spacer in between, finger tighten new Nylock nut down fully (push mount up by hand to assist) do not do up tight at this stage (note NO washer on bolt or nut for these mounts)....

It specifically states that the washers and crush washers are not used for the 3 large bolts, when in fact, they are supposed to be used, otherwise, why are they included with the kit? I think it is supposed to say to use both the washers and crush washers on the 3 150mm bolts.

 

[BulletHead]

Rest of orders will be fulfilled next week. Finally... thx for being patient. I also have a few extra kits if anyone else is interested.

 

[GX-R]

I am interested.

 

[cruiseroutfit]

Rest of orders will be fulfilled next week. Finally... thx for being patient. I also have a few extra kits if anyone else is interested.

Yup. I'll take one. How many do you have left?

 

[BTUMAN]

Let me know if you have one left.

 

[TexAZ]

Any update on the status of the diff drop kits?

 

[BulletHead]

I have mailed couple last week. More expected end of next week. Sorry for delay.

 

[TexAZ]

No problem, thanks for the update.

 

[shellb]

Any update on when we might get our shipments? Starting to plan my mods!

 

[cruiseroutfit]

Any update on when we might get our shipments? Starting to plan my mods!

x2

See my PM please

 

[BulletHead]

i was only able to ship a couple last week. expecting the rest of them in a couple of weeks. i notified the lucky parties.

 

[TexAZ]

I'm running a little over 3" of lift and was feeling a vibration right after starting to move. Worried about the drive line angles, I bought a Tundra diff drop kit for 28$. The hardware fits. It isn't as stout as the stock bolts, but it is enough to get by until the kits are available.
the skid plates bolted back on, but I had to leave off the steel "cups" that guard the diff mount bolts.
The vibration is gone, and I noticed some wear on the CV boots due to the angles, so it was worth it (IMO) to run the Tundra kit until these become available.
Any word on when to expect the next batch of kits?

thanks

 

[BulletHead]

I'm getting daily updates from this new machine shop. Mid-November should be the next batch, so far tolerance is within spec of the pieces I have reviewed.

 

[9780LC]

Hello, Thank you for putting this together. I'd like to buy a diff drop kit if you have one available.
Could you please let me know? I sent you a PM too. I don't know if you got that or not.

Thank you,

Bart Williams

 

[TexAZ]

Any status update on this kit? Its been 6 months since the last post.

 

[MEMCruiser]

I would want one also if available.

 

[malloc]

would also be interested

 

[BulletHead]

It's just painstakingly slow machine shop but their quality is great, much better than before. Sorry about the wait. Sometime in June I should be caught up with the current orders. Any subsequent orders should receive expect a 6-month delay.

 

[Haggis]

I am interested as well.