Ok, probably a Dan question again, but here goes. Cruise control wasn't working on scout trip over to Needles for canoe trip this past weekend (all 600 miles). Cruiser flew down I-40 at 75-80 the whole way, and as usual was great for the road trip. Cruise control would have been nice and it's always worked in the past. Light would come on the dash when I turned on and when I went to set a speed the dash light would blink three times and go out. When I tried to turn on again nothing worked and the dash light wouldn'd come on either. I can duplicate this process after I switch the ignition off and then restart the engine. I can only think that something resets when the ignition is turned off and then back on. Coming into work this morning I decided to play with it again and it worked just fine. I HATE intermitent problems like this! Any ideas gang? Is there a cruise control module that may be going bad after 9 years, a loose connector.....? Am I looking at some $$$ to replace/fix? The cruise control is nice for the longer trips I take almost monthly with our scout troop.
One the fun side, the canoe trip was great aside for one dumbass fawker on a PWC that decided to spray and swamp one of our canoes on the Colorado. What an ASS! He didn't even stop to see if our guys were ok. Just shouted 'You're going to get wet' as he sped by. Got some practice T-boning a canoe with my son as a result of this jerk.
One the fun side, the canoe trip was great aside for one dumbass fawker on a PWC that decided to spray and swamp one of our canoes on the Colorado. What an ASS! He didn't even stop to see if our guys were ok. Just shouted 'You're going to get wet' as he sped by. Got some practice T-boning a canoe with my son as a result of this jerk.