Clutch slave cylinder help

[21NDone]

Application: 1972 (09/71 build) FJ40.

Aft slave attach point is not aligning. What am I missing? Anyone have pictures of theirs installed?

View attachment 3594083

 

[charliemeyer007]

I'm not sure but perhaps that bracket goes on the outside and you use the other hole. It's snowing right now and I don't want to go lay in the mud to try and get a pic. I'll do it tomorrow if no one else can help you out. Putting the camera on the charger now.

 

[sogafarm]

From my ‘75

 

[firemanj92]

see post #1070+


Builds - Salt wagon My first fj40 (build) - https://forum.ih8mud.com/threads/salt-wagon-my-first-fj40-build.1297967/page-54#post-15385994

and

Builds - 1963 FJ45LP SWB Fixed Top "Sweet Simplicity" - https://forum.ih8mud.com/threads/1963-fj45lp-swb-fixed-top-sweet-simplicity.1026303/page-20#post-12259546

 

[21NDone]

Thanks for the responses. Looks like I’ll need that unique bolt too. Boarding a plane now. Will read through the referenced posts tonight.

 

[21NDone]

Circling back on this subject.

Application: 1972 (09/71 build) FJ40, clutch slave cylinder mounting.

@firemanj92 - Thanks for the reference links, awesome information. My application is a 3-speed on the floor making me believe I don't need the unique bracket or bolt setup for the 3-on the-tree configuration - am I wrong. Is it possible the engine mount is incorrect? FWIW, I am installing a new clutch slave cylinder. I'm digging up the one removed to make a comparison and trying to get better pictures of my setup.

 

[21NDone]

Found this link: Clutch slave cylinder / fork alignment - https://forum.ih8mud.com/threads/clutch-slave-cylinder-fork-alignment.1329237/

Very good information, may be just what's needed to address my condition. Will follow up....