Bumper build up! (1 Viewer)

[1985bj70]

Nice work on the bumper, I like it....

 

[ducatiman81211]

rear bumper

Sorry, I have been gone traveling Mexico and Utah.
Here's a picture. The red clamp helps in case ever I needed a backup for the swing away tire/hi-lift holder staying put. It uses a steel type hole/pin w/spring for locking down too.
Found out water/fuel jugs fit in the "step" perfectly, and I can carry jug up front on the PTO/Bumper area.
Nice work.

Hey ducatiman I love that rear bumper. What is the clamp just to the right of the hitch receiver? It looks like it's to support the door/spare tire carrier? I can't really tell. I'm thinking through getting a new bumper made since I've beat my original back into place so may times its gone soft. I can "adjust" it with a lightweight ball-peen hammer now... It's just hanging on there for bling factor and to kill my departure angle.

 

[eleventhirtyfour]

here it is?..... does the people like it???

Next projekt!!! I think this is going to be nice????

"firkantrør til feste"

Does this mean you're going to have square mounts for the rocksliders to make them removable? Love to see pics when you do it!
Really nice clean work on the front bumper too.

 

[Crunsh]

yes i hawe a idea about a offroad slider and a day driver step board!

but i`m afraid it is going to be shaking when i drive on ruget terrain????

 

[SteelArt]

Looks good .

 

[ildhane]

it looks very good, by far the best looking front bumper for the LJ front be far imo. And it looks quite legal
I have seen several guys on this very forum mounting this kind of sliders with a plate bolted on each side of the frame and never read any complaints about this solution.