Having trouble figuring out what to do for brakes. Have '63 fj40 that has odd year fittings. The fittings are 8mm x 1.00. According to Toyota they are the only ones that made them and they are not readily available. I need to change out all of the lines. To do so, I need to replace these fittings because mine are not reusable. Problem is, I cannot find these fittings anywhere. Any suggestions? Is it possible to drill and tap the wheel cylinders for an american fitting, then I could change over to standard lines, which would make it much easier if anything broke to find a replacement. Other thoughts? Also, considered disc brake conversion, but worried about cost. Anyone out there have an estimate on that, where to get parts etc. Just want this thing to be able to stop good, and not cost me an arm and a leg. Finally got the motor, tranny, and t-case in and wiring redone. A little anxious to get it going down the road. Now just need to make it stop.