- Thread starter
- #41
I think I am on the downward slope now.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
did you source a new bottom windscreen rubber ken. cheers
- Thread starter
- #43
She lives again
Vossie
#thecrazycruiserman
sounds good.
- Thread starter
- #45
2.5" Stainless exhaust fitted. First drive which wasnt too far but felt good. She is sucking air into the fuel lines still.
- Thread starter
- #46
Test fit of the roof bar light. Also dont you hate it when you put a coat down and then realise that you dont have enough activator for a second coat.
- Thread starter
- #47
Storage all sorted out for the rear of the shorty.
- Thread starter
- #48
Roof lining is now in and the roof temporarily in place. Hopefully the glass will be fitted next week and then wiring done and installed mid February. Should be ready to put back on the road by the end of February once I sort out an issue with air getting into the fuel lines.
Vossie
#thecrazycruiserman
are those fyrlights?
- Thread starter
- #50
- Thread starter
- #51
Had a play with the modified air hammer for putting in roof rivets today. I think this will work.
Hi Ken,
Please make a few photos of engine compartment. How did you realize intake heating?
Please make a few photos of engine compartment. How did you realize intake heating?
- Thread starter
- #53
Hey mate havent gotten around to finalising the air filter box or intake heating atm. Heating pipes are just blanked off at the motor until I work out what I am doing.
- Thread starter
- #54
Took her out for a bit of sunshine today. Managed to drive her in and out.
- Thread starter
- #56
Will get a pic up when I get home from work or tomorrow.
- Thread starter
- #57
Dual wheel carriers.
- Thread starter
- #59
Yeah mate I think that it is long gone unless someone decides to make a reproduction run of it.
- Thread starter
- #60
Just a quick update on Ruby's progress. Air box is done and I am only hooking up one snorkel at this time. New seatbelts arrived today and the wiring is almost done. So far we are up to two fuse boxes with about 18 fuses in each box.
