Builds Big Red Toy (2 Viewers)

[The Phoenician]

Did some plinking with my son and friends. Was impressed with the 45-70 @the 45 yard line. Finally shot my 44 magnum. I think I have a new favorite caliber.

when i get back, I'll have to replace the TREs on Big Red. It's been wandering all over the road.

 

[The Phoenician]

End to a perfect weekend. Also a great way to finish the year.

 

[The Phoenician]

Finally used the seats and brackets I had sitting in my shed for almost a decade.

 

[The Phoenician]

And back in the Middle East.

 

[The Phoenician]

This showed up. I hope to get it on Big Red tomorrow.

 

[The Phoenician]

Got it installed with the help of Hunter from Land Cruiser Specialist. Can't say enough good things about him. I think it looks good and is sturdy. Big Red drives like it's not even on there.

This frees up the front basket and gives me the option to go camping without towing the trailer.

 

[The Phoenician]

I used to think squirrels were ok. Now I want them all dead.

 

[JoeW]

On that motor, are the knock sensors in the valley behind those two coolant pipes? Technically the heads have to come off to get the pipe out? I had to do a knock sensor harness due to rat damage as well. You can actually snake the harness out without having to pull everything if you have a boriscope, a coat hanger, and some long picks.

The other option is to cut the coolant pipes and remove them independently.

 

[The Phoenician]

On that motor, are the knock sensors in the valley behind those two coolant pipes? Technically the heads have to come off to get the pipe out? I had to do a knock sensor harness due to rat damage as well. You can actually snake the harness out without having to pull everything if you have a boriscope, a coat hanger, and some long picks.

The other option is to cut the coolant pipes and remove them independently.

I'm not sure, I sent it off to Landcruiser Specialist and they got it done in like two hours. I'll ask him tomorrow and confirm.

 

[The Phoenician]

On that motor, are the knock sensors in the valley behind those two coolant pipes? Technically the heads have to come off to get the pipe out? I had to do a knock sensor harness due to rat damage as well. You can actually snake the harness out without having to pull everything if you have a boriscope, a coat hanger, and some long picks.

The other option is to cut the coolant pipes and remove them independently.

Just closing the loop on this. I spoke with Hunter. He says it was straight forward. You take off the manifold and everything is really accessible.
What engine did you have? The 4.0?

 

[JoeW]

Just closing the loop on this. I some with Hunter. He says it was straight forward. You take off the manifold and everything is really accessible.
What engine did you have? The 4.0?

This was on an FJCruiser, so that maybe older than your truck. I'm not very well versed on the Tacoma powertrains.

Those rats were so bad they ate a hole in the gas tank too.

 

[zeeklafreek]

I'm not sure, I sent it off to Landcruiser Specialist and they got it done in like two hours. I'll ask him tomorrow and confirm.

Say Hey to Edwin and Kevin.

 

[The Phoenician]

Say Hey to Edwin and Kevin.

Will do

 

[The Phoenician]

Got to see some old friends today and some great beauties...

 

[The Phoenician]

What are the odds the owner is called Jake?