Where did you get that? I I need one of those made with Carling switch holes
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #62
@CruiserHeadParts
Cruiser Head Parts for Toyota Land Cruisers
Aftermarket parts for your Toyota Land Cruiser Here at Cruiser Head Parts custom reproduction modification hardware FJ60 FJ62 4runner aftermarket fj60 solutions FJ70 70 catalog cruiserhead.com cruiserheads cruiserheadparts store shop automotive panel switch bezel surround 3d print printed gauge...
cruiserhead.com
- Thread starter
- #63
And so it begins…
The crank pulley zipped right off. It’s nice have a cat mechanic as a neighbor. Plans as of now:
Replace all the gaskets on the front
New water pump
New thermostat
Add 3 groove pulley
Add sag PS conversion
Add A/C compressor
Line X inner fenders and core support
The crank pulley zipped right off. It’s nice have a cat mechanic as a neighbor. Plans as of now:
Replace all the gaskets on the front
New water pump
New thermostat
Add 3 groove pulley
Add sag PS conversion
Add A/C compressor
Line X inner fenders and core support
- Thread starter
- #66
Holy $hit we have A/C! It’s wild to think this rig did not come with AC yet all the wiring was there. Just had to bolt everything in and we are set. Still need to do a temp test.
Looking into doing a Hyperspark distributor and box to compliment the Sniper.
Looking into doing a Hyperspark distributor and box to compliment the Sniper.
Last edited:
- Thread starter
- #67
Pulled the cargo and rear hatch windows in preparation for ceramic tint tomorrow. They could have done the tint with windows in place but this will be much cleaner. Plus I have new gaskets to install.
Always nice to see no rust.
Always nice to see no rust.
