Hey all,
Good sunday morning! My friend Hilux installed the aussie locker in my rear of my '94 yesterday, and the first tolerances measurements were at .07 where the range on the instructions were .06 to .20 My question is, there is racheting in the rear (as I have been prepared for) but do I need to go with a thinner thrust washer to make the tolerances a bit more to the middle of the range, and would that make the racheting sound lighter? Also, is there a "break in period" for the aussie locker? Another thing to add is, my rear drive shaft is pulled right now getting a U-joint replaced, and don't know if that has anything to do with more noise in the turns without torque applied from the rear. Any advice would be appreciated!
cheers,
Joel
Good sunday morning! My friend Hilux installed the aussie locker in my rear of my '94 yesterday, and the first tolerances measurements were at .07 where the range on the instructions were .06 to .20 My question is, there is racheting in the rear (as I have been prepared for) but do I need to go with a thinner thrust washer to make the tolerances a bit more to the middle of the range, and would that make the racheting sound lighter? Also, is there a "break in period" for the aussie locker? Another thing to add is, my rear drive shaft is pulled right now getting a U-joint replaced, and don't know if that has anything to do with more noise in the turns without torque applied from the rear. Any advice would be appreciated!
cheers,
Joel