I recently swapped out an F for a 2F (In a 1970 FJ40). I have everything back together except for two things that I cannot seem to figure out. I cannot get the clutch slave cylinder figured out. It hooks on the drivers side rear motor mount, but I cannot remember the correct way to put all of the parts in the correct order (see picture). I have not been able to find a photo in my Haynes manual or Toyota factory manual that shows the whole set up. I specifically need to see how it hooks to the motor mount and the column shift linkage. Also, in thanks for all the free advice I've received on this site, I'll donate ten bucks to the web support fund in your name, if you are the first to direct me to a photo or answer to my problem. Thanks in advance.