Air compressor fitting ID help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

jjdeneen918

SILVER Star
Joined
Jul 23, 2008
Messages
1,194
Location
Long Beach, CA
Came off the Wits End air system manifold.

It’s got a small pin hole on the main tightening facet that is constantly spewing air, not allowing my rear tank to fill.

Hopefully someone can help ID this part.

I’m at Grainger now, they can’t identify it either.

IMG_1699.jpeg
 
Those are all my thoughts too.
I also google images it, numerous types of valves appeared, but nothing was specific.

If anyone knows for sure, a part number or link to a site would be amazing.

I haven’t found anything yet myself, at Grainger, or Napa.
 
Those are all my thoughts too.
I also google images it, numerous types of valves appeared, but nothing was specific.

If anyone knows for sure, a part number or link to a site would be amazing.

I haven’t found anything yet myself, at Grainger, or Napa.
I would email those pictures to pneumatic part stores and see if they can ID it. They can help you better than a car enthusiast forum
 
I got some better/more complete pics now that I’m back at the repair shop.

It threads directly to the inlet of the manifold. There is an AR adapter fitting to attach the inlet hose to the non vacate side of it.

IMG_1701.jpeg


IMG_1702.jpeg


IMG_1703.jpeg


IMG_1704.jpeg
 
Just by the above photo only, it’s hard to say 100%.

I do think I found it at McMasterr-Carr.
Part number 8549T16. $36.10.

I ordered it & will show up tomorrow to confirm.

IMG_1705.jpeg
 

Users who are viewing this thread

Back
Top Bottom