I am almost done with putting my FJ60 back together. But need to make sure that I have the proper pre-load set for both the Knuckle and Wheel bearings, as I don't know what they should be set to. As I would like to get this correct so that I do not have to take my FJ apart again for a long time. As I have Pulled the thirds and put thirds with 4.11's, and I have finish re-torqued my lift in the front, and changing my tie rod ends.
Any help or link to what the preload should be will help.
Thanks,
Yoda85
Any help or link to what the preload should be will help.
Thanks,
Yoda85