‘75 FJ40 Motor Mount Bolts

[meatloaf]

Having a hard time finding Toyota front/rear motor mount bolts, bolts that attach mounts to the bell housing and bolt that attach tranny to bell housing. Any recommendations on where to find these? Or does anyone know the required size, thread pitch and length on these.

Thanks,
ML

 

[kunzma]

Here's some information in this thread. Post #6 specifically.

Need help sourcing front engine mount bolts for 1969 fj40

Here's a pic of the placeholder bolts I have in the mounts. They are too long, though I think the right threads per inch and diameter. I've been searching on the interwebs to find 2 mounting bolts for my front square SOR engine mounts. It's a 1969 fj40 and I can't seem to find the bolts. I can...

forum.ih8mud.com

 

[cruisermatt]

Here's some information in this thread. Post #6 specifically.

Need help sourcing front engine mount bolts for 1969 fj40

Here's a pic of the placeholder bolts I have in the mounts. They are too long, though I think the right threads per inch and diameter. I've been searching on the interwebs to find 2 mounting bolts for my front square SOR engine mounts. It's a 1969 fj40 and I can't seem to find the bolts. I can...

forum.ih8mud.com

Maybe Luis can post up some pics of the hardware I got him hooked up with.

 

[kunzma]

Rear Motor Mount Bolt differences

forum.ih8mud.com

Rear bolts. 90102-13010 (edit- Toyota dealer says that number is NLA)

 

[meatloaf]

Thank you @kunzma! @cruisermatt had already hooked me up with the needed bolts. I’ll post a picture later

 

[kunzma]

Working through this issue myself @meatloaf . Nice to pull it all into one thread.

 

[kunzma]

@cruisermatt Wondering if I could get a couple of the long bolts for the rear engine mounts?

 

[cruisermatt]

@cruisermatt Wondering if I could get a couple of the long bolts for the rear engine mounts?

Unfortunately those are NLA.
They're the odd-duck 13mm.

Your options are used OEM, I think Mark @65swb45 has some NOS ones, (he probably has good used ones as well. I'm sure Georg/SOR/Classic Cruisers/MAF/BTB all have good used ones as well), or use generic 1/2"

 

[Fzjrvakma]

Same issue over here, but I'm still not seeing a source for the castle nut setup? I assume locknuts are not acceptable?

 

[cruisermatt]

I believe @ToyotaMatt has those now.