With stock joints, the goal is not to point the pinion at the transfer case. It is to make the pinion flange and transfer output flange parallel. Run it how you want, but you had it right the first time.
Yes a proportioning valve will be needed and a good quality brake line flare tool. Poser kit for me as well. He has been great to work with for several transactions.
I believe i’ve seen other examples of 33’s on stock suspension. Ok on easy roads, just not articulated off road. Your results will vary whether you are on 5.5” OE wheels or something wider with different offset. Look up “wngrog” builds as he...
I'm looking for PS pump for 1986 Toyota pickup 4x4. Do you have a part number or specific model vehicle that this was supposed to be for so I can do some cross referencing? Thanks, Lance.
Assuming stock leafs, you have a minimum 2” lift over stock with your current setup. This should allow 33x10.5 tires with little drama. If you go 33x12.5 you will likely have some rubbing in the rear wheel wells when articulating off road, but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.