7 pin trailer harness - anyone know the screw size to mount the harness?

[Baezventures]

I was looking for a part number or the screw size for the two screws that mount the trailer 7 pin wire harness for 2011 LC 200. Any insight would be much appreciated! I got the harness but did not realize the screws were not there.

TIA

 

[TeCKis300]

It's likely an M6 (6mm diamater) bolt you need. By whatever length. M6x10 should do it.

Are you installing a hopkins or OEM harness?

 

[Taco2Cruiser]

M8x1.25x25

It's the same bolts that hold the stock skid plates and the spare tire carrier to the frame.

 

[Baezventures]

M8x1.25x25

It's the same bolts that hold the stock skid plates and the spare tire carrier to the frame.

 

[Baezventures]

This is awesome! Thanks!

 

[Baezventures]

It's likely an M6 (6mm diamater) bolt you need. By whatever length. M6x10 should do it.

Are you installing a hopkins or OEM harness?

 

[Baezventures]

Thank you for the measurements!

 

[Baezventures]

M8x1.25x25

It's the same bolts that hold the stock skid plates and the spare tire carrier to the frame.

The 8m was too wide. Might be 6m. I will go to the store to see if that is it.

 

[MScruiser]

You are not a true die hard fanatic unless you buy JIS m8x1.25.

 

[Taco2Cruiser]

The 8m was too wide. Might be 6m. I will go to the store to see if that is it.

Interesting, I have an '11 and very recently bolted the harness bracket back on along with the spare tire carrier. And they were all M8x1.25

I'm not saying you're wrong at all, in fact this goes inline with the 200 frame having different captive nuts welded in with no distinct ways of know when a change happened.

If yours is M6, then this will be a good thread to help warn people in the future.

 

[TeCKis300]

I'm almost sure mine is an M6. I'll be under there again to replace my Hopkins harness.

OP, are you installing an OEM or Hopkins adapter? I'm working with Hopkins now as it looks like they're harnesses are built with the assumption it would be tied into a sub-harness point which has a different pin-out.

 

[TeCKis300]

Taco2Cruiser was right. Verified as an M8 1.25 thread pitch.