60 series....Tech and Classifieds

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Ballpark h55 into a 62 and who would you have do it?

You need the following:


1. H55F: $2300

2. Clutch master

3. Clutch slave

4. Hard lines and soft line for the clutch system.

5. Flywheel

6. Clutch system (pilot, clutch disc, clutch cover, throw out, fork, clips, boot, hub, bell housing).

7. Cross member and mount + hardware.

8. Pedal bucket

9. Cutting hole in floor and making it happen.

10. LABOR.

$3-5k is on the low side. I tell folks $6-7k
 
He is right on money at $6/7. I have a lot of the parts and could never make the $$ work in my head. Said part is your better be 100% lifer in that truck. By a 60 and never look back.
 
You need the following:


1. H55F: $2300

2. Clutch master

3. Clutch slave

4. Hard lines and soft line for the clutch system.

5. Flywheel

6. Clutch system (pilot, clutch disc, clutch cover, throw out, fork, clips, boot, hub, bell housing).

7. Cross member and mount + hardware.

8. Pedal bucket

9. Cutting hole in floor and making it happen.

10. LABOR.

$3-5k is on the low side. I tell folks $6-7k

Clutch pedal.

Plus new driveshafts or have yours retubed.

The small stuff adds up fast. Once the $$ factor wears off having a manual behind a 3FE is so worth it.
 
Lx570
 
Backroads in the 60. Nothing like it.

image.jpeg
 
Not a single pic of the engine...
 

Users who are viewing this thread

Back
Top Bottom