60 series....Tech and Classifieds

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Ballpark h55 into a 62 and who would you have do it?

You need the following:


1. H55F: $2300

2. Clutch master

3. Clutch slave

4. Hard lines and soft line for the clutch system.

5. Flywheel

6. Clutch system (pilot, clutch disc, clutch cover, throw out, fork, clips, boot, hub, bell housing).

7. Cross member and mount + hardware.

8. Pedal bucket

9. Cutting hole in floor and making it happen.

10. LABOR.

$3-5k is on the low side. I tell folks $6-7k
 
You need the following:


1. H55F: $2300

2. Clutch master

3. Clutch slave

4. Hard lines and soft line for the clutch system.

5. Flywheel

6. Clutch system (pilot, clutch disc, clutch cover, throw out, fork, clips, boot, hub, bell housing).

7. Cross member and mount + hardware.

8. Pedal bucket

9. Cutting hole in floor and making it happen.

10. LABOR.

$3-5k is on the low side. I tell folks $6-7k

Clutch pedal.

Plus new driveshafts or have yours retubed.

The small stuff adds up fast. Once the $$ factor wears off having a manual behind a 3FE is so worth it.
 
Backroads in the 60. Nothing like it.

image.webp
 
Not a single pic of the engine...
 
Took the thermostat out today. It looked like a Barbical on the bottom of a pirate ship.

image.webp


Temp gauge went from 1/4 to just under 1/2 and heaters blew super hot.

Hope it stays cool in the summer like it did
 
Back
Top Bottom