2f engine bracket bolt sizes front and rear (1 Viewer)

[Toby755]

Does anyone know the bolt sizes for the engine brackets that go into the block and bell housing for a 1979 2f?

There are two brackets on each side of the drive train, and I don’t know the bolt sizes they did not match up with the F bolt size. Thank you!

 

[brian]

where in pa?

 

[Toby755]

where in pa?

I’m in Walnutport near Bethlehem.

 

[charliemeyer007]

From the freq ask questions above
Motor Mount Bolt Size
12mmx1.25x25 is the bolt that holds the cast mount piece to the engine block...
12mmx1.25 is the thread size/pitch bolt that attaches the cast piece bolted to the block to the engine mount.

12x1.25x 35 or 40mm Front and rear mounts
Poser

 

[Toby755]

From the freq ask questions above
Motor Mount Bolt Size
12mmx1.25x25 is the bolt that holds the cast mount piece to the engine block...
12mmx1.25 is the thread size/pitch bolt that attaches the cast piece bolted to the block to the engine mount.

12x1.25x 35 or 40mm Front and rear mounts
Poser

Thank you!

 

[charliemeyer007]

FAQ - 40-series FAQ

Welcome the the frequently asked questions about the Fj40 and Fj45. As Fj55's share a fair amount of components, there may be some links to posts involving 55 series. The FAQ will be locked, but the topics that are linked to will still be open, so if new info comes up, or someone has a...

forum.ih8mud.com

 

[Grayscale]

I'm fairly certain that the rear bolts (bellhousing) are 13mm. I used Grade 5, 1/2-20 because it was closer to the originals, size and fastener material. I drilled the bolts and nuts for cotter pins.

Oops, I misread the question. I wasn't thinking about mount-to-block. I was thinking about the motor mount bolts, not the screws that thread into the block.

 

[cruisermatt]

the bolts into the bellhousing are coarse pitch. M12x1.75

 

[Toby755]

I'm fairly certain that the rear bolts (bellhousing) are 13mm. I used Grade 5, 1/2-20 because it was closer to the originals, size and fastener material. I drilled the bolts and nuts for cotter pins.

Oops, I misread the question. I wasn't thinking about mount-to-block. I was thinking about the motor mount bolts, not the screws that thread into the block.

Thanks!

 

[Toby755]

the bolts into the bellhousing are coarse pitch. M12x1.75

Thank you!