Wanted 2F Block (072150-080166 Only) Feeler

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 16, 2011
Threads
337
Messages
12,312
Location
Tulsa
Location
United States
Exploring options that I can't say viable until this request is made and money discussed.

If you disagree with my intentions, I really don't care, as I'm not asking for opinions in this thread.

There's others I've authored to ridicule the request, and an easy search should result any number to post opinions on, or PM your opinion to me. :)

072150-080166 (January through February of 76) only, as I'm not interested in any outside that range. (080166 is a "Best Guess")

I don't want the complete engine, just a known bore-able block, but not ruling out the first.

It will have to be packaged or palletized, unless within a reasonable distance from Tulsa, OK, so please weight that into considerations.
 
I will check Monday the SN on the 2F I have, I know it's a later 2f since it has the oil cooler but that is all I know. You can come out to CO and do some wheeling while you are out here if the snow doesn't start falling.
 
You are correct, no bad news, just logistics....

Please take this, no charge, if by some miracle it can be picked up. Seems we might have mutual friends in the Denver area and I owe them some doors....I am without truck now and have not been able to deliver

2f photo.webp
 
You are correct, no bad news, just logistics....

Please take this, no charge, if by some miracle it can be picked up. Seems we might have mutual friends in the Denver area and I owe them some doors....I am without truck now and have not been able to deliver

Pondering logistics.

To your knowledge, has it been bored before?
 
I do not know...I would assume that if it was bored over it would have new pistons and rings... the motor was either painted or rebuilt over ten years ago, well before pistons of this vintage became a bit rare.

I can open it up in early December...
 
I can open it up in early December...

I wouldn't think it'd have been bored out to the size I'm planning, since they may still have had decent inventory of pistons ten years ago.

No need for the extra work, since it'd be punched out anyway.

Trying to figure of logistics of getting to Boulder.

Have another recent acquisition even further north of you that'll be a small feat to get to OK.

Wishing I had a Cruiser that could make the trip to get all and haul all back, but it'd be cheaper to ship overnight air than to drive the 80 and all I have that's running.
 
Back
Top Bottom