Builds 2F + (3F-E) = 2FETI Into My FJ40 (2 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Final spec are in so here are the official figures.

Cam Specs

IMG-19.jpg


Engine Specs

IMG_0003-2.jpg

IMG_0003_2.jpg


IMG_0002-5.jpg
 
Last edited:
I cant wait for Matt to come and visit me to take me for a spin, ;) :steer: it was terrifying enough driving to the parts shop with no doors on :D

BJ

Lucky Bum, the best I can hope for is a YouTube video. :crybaby:

How's the swap going Matt? Got the 2F pulled? Working on the wiring? :bang:
 
Final payment on the engine will be made next Tuesday and Delivery will be same day. All I have to say on this matter is :censor:

On a better note,

I bought a few more goodies

The air Cleaner 4in in and out, same size as the Turbo inlet:eek:

100_3490.jpg


100_3491.jpg
 
Last edited:
O2 Wide band 5 wire sensor

100_3494.jpg


100_3496.jpg
 
Coil pack and ignitor for wasted coil set up.

 
Last edited:
Ya, and checkout the thickness of that bench top.

1/2" steel plate, Matt?

It's very solid just incase you need the BFH:D

My Mech's, place, when I bought this truck along time ago I was very green, now most of the work I do myself at his place. He still gets a few good jobs out of me to keep him sweet when I'm too busy. He actually gave me the keys to the place when we had to rebuild the truck after a little indiscretion with a tree.

TOP BLOKE
 
All that kit on show and the vice and bench get the attention!

Where is the O2 sensor going, on the 2F it was easy for me, the fancy split manifold on the 3F must make it harder to keep it close to the maniold, although I have an and exhaust gas temp sensor which made the location more important.
 
That looks like it will work well, quite tight space and it will get hot for the wire near the turbo, bit of extra insulation on the lead might be a help.
 
That looks like it will work well, quite tight space and it will get hot for the wire near the turbo, bit of extra insulation on the lead might be a help.

Heat will be an issue but it will all be ceramic coated unlike the one pictured and shielded as best I can.
 
Oh yes:bounce:
100_3504.jpg
 
Even better I started bolting bits too it :D

All torqued to Toyota 3FE spec's polished the rust out before bolting it up too, just moisture.

100_3509.jpg


100_3510.jpg




I cant't wait to :steer:
 
Last edited:
Very nice looking!
 

Users who are viewing this thread

Back
Top Bottom