I am adding an OME 2'' inch lift kit to my 60 series. I don't want the back to appear higher than the front, should I have the supplier take out a rear leaf before they ship.........thanks
2" Lift Kit question?
- Thread starter yohitcobra
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
get it and put it on and go from there. every truck is diferent.
x2 play it buy ear
After changing out the leafs for some new ones my 62 was sitting too high in the rear for my taste. I took my rig to a local spring shop and had them "re-arch" the rears so it would sit level. That did the trick !! 
Ass up
Ass up is good for 60 cruisers....
More load capacity before its draggin & saggin
better angle for not scrapping such a long truck when
entering steep climb
just my .02
Ass up is good for 60 cruisers....
More load capacity before its draggin & saggin
better angle for not scrapping such a long truck when
entering steep climb
just my .02
