Hi everyone,
I have a pickup FSM and a 80 series FSM, and neither seem to show how the brake lines are run.
I want to make my 4Runner have brakes only on the front until I can get the burst rear line replaced. There's two lines off the master cylinder and looking at it, I thought the one closer to the front of the vehicle was the front brakes. I plugged the rear part on the master cylinder with a Absolute Witt's End plug, but it doesn't seem right. Is it a diagonal setup, where one port on the master cylinder does one diagonal?
Thanks!
Related: 1st gen 4runner brake line rupture near fuel tank: Routing question - https://forum.ih8mud.com/threads/1st-gen-4runner-brake-line-rupture-near-fuel-tank-routing-question.823403/
I have a pickup FSM and a 80 series FSM, and neither seem to show how the brake lines are run.
I want to make my 4Runner have brakes only on the front until I can get the burst rear line replaced. There's two lines off the master cylinder and looking at it, I thought the one closer to the front of the vehicle was the front brakes. I plugged the rear part on the master cylinder with a Absolute Witt's End plug, but it doesn't seem right. Is it a diagonal setup, where one port on the master cylinder does one diagonal?
Thanks!
Related: 1st gen 4runner brake line rupture near fuel tank: Routing question - https://forum.ih8mud.com/threads/1st-gen-4runner-brake-line-rupture-near-fuel-tank-routing-question.823403/