question

First time on the Tundra post. Has anyone done a tuning on their ECU, there is a company in Cali called KDMAX PRO TUNER Stating it can tune ECU give better fuel, throttle response, horsepower and increase torque.

Hey there everyone, I am just wondering how I determine which wheel cylinder adjusts which shoe Thanks

So, on the 'tailgate', what is under the carpeted area, where there are 4 fasteners? Is it storage, or access for something else? Also, with the third row seats up, does anyone know the width of the space in the back? Would it be able to carry sheets of 4 x 8 plywood or sheetrock? Forgive my...

Hi friends! Quick question. My heater only throws heat if it's all the way to the right, I move it one down and it's cold air. My heater blows the four different setting speeds. But only throws heat when it's hard right. Is this normal? If not, suggestions for rectifying? It's been this way...

Saw some posts and discussions about a FJ40 specific top cover being reproduced. What's the purpose of this? Is it required in order to put a H55F in a fj40? eBay listing below...

I started having a vibration in the LC a few weeks ago. you can feel it in the floor, seat and steering wheel. So I replaced the ujoints with toyota parts then had the shafts balanced. problem seems to have gotten worse. I decided to take it to the dealer for a diagnosis. after 3 days, they...

I have a 1994 FZJ80. I recently replaced the alternator with an Denso replacement from @cruiseroutfit. Still was having issues with a dead battery on occasion. I replaced the fusible link and installed a new battery tonight. I had the old one tested and it had gone bad. I had them test the...

Do the FZJ80, HDJ80, and HDj81 all share the same transfer case, or do they have differences? Thanks in advance.

The 2 Bilstein shocks I'm removing each have 2 cupped washers with a rubber spacer between them, at the top of the shocks. The new OEM shocks I received each come with 2 thicker rubber spacers (90948-01064). Do I need these? How should they be placed? The dealer also said I needed these 2...

What puller do you recommend for pulling a 2f crank pully? The puller I have seems to be too small. Thanks!

Happy New Year everyone! The last piece of my puzzle is going to painter this week LWB truck bed. My other passion is bicycling. In a previous FJ45 I carried a piece of foam in the bed and just laid my bicycle on it. Since this one is not painted yet, just wondering if anyone has ideas. I...

Hello All, My name is Max and I am the proud new owner of a ‘77 fj40(pictured; likely a Columbia FJ since there’s NOTHING in place to add a heater). It’s in great shape and restored by the PO, but he’s in Florida where there’s not much need for heater…which is a little different than...

How important is it for this pin to be in the hole? Can i just angle grind it off? Im clocking the turbo

My 95 has a blown head gasket after flogging it to death pulling a box trailer for a month for work while searching for a new V8 Sequoia to replace the one my daughter totaled. I'm getting ready to replace the HG in the truck, and have a good spare engine (also with a minor HG leak) to mix/...

So, after quite a struggle, I've installed the new Warn winch and it works just fine. But then - the Cruiser won't start. All the lights, A/C, radio etc but not turning over. Check fuses. Can't find obvious problem. Passenger foot well fuse box pic attached. Engine bay fuse box pic attached...

1991 FJ80, a while back I had a shop who said they were experienced with Land Cruisers rebuild the front end -- axles, steering knuckles, maybe some other stuff, I don't remember. The axles they used were aftermarket, they have two outboard grooves for a snap ring, I suppose for different...

1991 FJ80 locking center diff only. 207K miles +/- when I got it, about 213K now. Very poorly maintained before I got it. Had a terrible whine on acceleration and a lot of clunking and banging on shifting and turning. Front and rear tires were different brands and the rear tires were far more...

Not a question specific to the 80 series but I want to add heated seats. I picked up a seat heater switch out of an 08 Camry that would blend in nicely and look factory but I am unsure how I would go about wiring it. My plan was to just get a heated seat kit and ditch the switches in favor of...

Can anyone provide the inner oval cutout dimensions for this aftermarket grill? I want to keep the radar cruise and want to see if there's any possibility of the Lexus logo cruise badge of fitting the height dimension.

Hello All, I have a question. I purchased a TRD SUPERCHARGER KIT with a 9th and 10th injector and TRD ECU My question is, will this work on my 2001 Landcruiser I've read several threads that my 2001 model only has a 9th injector, is it possible to add all 10? What happens if I can only add the...