so I am trying to get all my obd monitors ready for a test tomm, drove like 60 miles today, on and off, different types of driving, etc and no luck in getting the CAT monitor to ready. This is the only one that is still not ready.
I was doing some light reading on the CA BAR website today and...
I recall reading that Toyota came out with a revised head gasket to address failures with the initial gaskets used at the factory. Is there a specific part number I should look for or just pick up what the Toyota dealer says is correct? On that note, can anyone confirm the part number? Thanks guys.
I've got a new second battery sitting around. Not a deep cycle, just a regular 800CCA one. I'm wondering about how to make use of it. I've seen rigs with dual-battery setups, but it seems you have to desmog, no? I don't see any other way of making use of the second battery tray location without...
I noticed that all the stock speaker wiring is part of a larger loom, making it difficult to remove and replace.
When you guys run new speaker wire, do you just run it in parallel to the existing harness and leave the old wiring still in place? I'm currently looking at just the rear passenger...
Hey y'all,
I have looked around this site a few times while trying to find some answers and finally choose to make an account and ask myself.
First, What is the desired idle on a 87 FJ60? (I ask because when I adjust the idle speed to low (below 700RPM) after driving and stepping on brakes...
A question for the experienced. Will a reduction box from a 86 w trans fit on a ax15 need an adapter or bolt up. And how strong will this set up be. HP, torque limits.