Took these OEM heat shield mounts of a brand new factory hood purchased from Toyota for my fj40. They were cut off so they could be welded into another hood that may need them. $15+ shipping.
Bj42 etc... OEM hood heat shield attachment arms. I bought an OEM hood 22 years ago from Toyota and it came with these mounting arms for BJ. I cut them off right next to the hood mounting point. Could be welded back to another hood for those of you that may need them.
Need some help (no pictures at the moment). I bought my June 1980 Fj40 20 years ago to restore. Long story short, I'm just now getting to the end of the restore. The original wiring harness was total trash so after tear down I put it in a box and bought a couple others on Ebay back in mid...
Need some help (no pictures at the moment). I bought my June 1980 Fj40 20 years ago to restore. Long story short, I'm just now getting to the end of the restore. The original wiring harness was total trash so after tear down I put it in a box and bought a couple others on Ebay back in mid...
Anyone know where I can get my gauge cluster restored or the kit for lettering/numbering? I think there was a company that made kits years ago but cant seem to make contact. Need it for a 1980 FJ40.
Thanks
I know its a stretch but I'm looking for original good condition (not torn and ripped) bottom seat covers that look like elephant skin for the 1980+ Fj40. i have two good backs. OR... any idea where to get the original material used. I know years ago a guy named Shane Walters in Oregon was...
I haven't noticed any restoration picture of this heat shield on late Fj40's mounted in the transmission tunnel next to the drivers right foot area. Do they all have them. What goes on the inside. I pulled it off and saw remains of foil and black sealant.
Up for grabs is damn near new old stock Fj60 exhaust down pipe is I've had for years on the shelf. I bought this from S.O.R. thinking I needed it which I didn't. A little surface rust from sitting on my shelf for years. Do not see any suit/carbon inside. $200 + shipping to your door.
I spent...
I am looking for one or two of the small PTO drive shaft U-Joints with the brass caps and no bearings. Every number I have been given takes me back to a larger U-joint with the standard steel caps. I've gone through NAPA, Autozone, Pep boys, O'Reillys etc... no luck. PTO came from a 74 Fj40
Looking for a nice PTO shifter floor seal for a late model Fj40 (1980) pictures attached that I found on mud of what I'm looking for. I'm in North East Texas. Thank you
I'm looking for a nice Hand Throttle and mounting hardware setup for my 1980 fj40 . I have the foot peddle already for the cable mount. A piece at a time may work also. Pretty much how this whole restore has been anyway. I'm in North East Texas. Thanks
Several years ago I bought an OEM power steering gearbox for my 1980 Fj40 and I'm now trying to figure out the heat shield installation. It should be fairly simple. I have four different mounting brackets and it seems that none of the combinations I try work. Hole alignment on the shield to the...
Anyone have the layout dimensions for the single pillow block mount on the later model fj40. Not the one under the radiator, the o e on the left frame rail fwd of shock mount. I need all the dimensions /angles etc... to make a couple. I have the bolt pattern. Just not the actual size.
Or a...
Anyone have the layout dimensions for the single pillow block mount on the later model fj40. Not the one under the radiator, the o e on the left frame rail fwd of shock mount. I need all the dimensions /angles etc... to make a couple. I have the bolt pattern. Just not the actual size.
Or a...