I ended up using the Morimoto in my setup - wiring is simple +/-. If you decide to go with the Stedi, I still have the new ones at my shop if you are interested.
My '05 has JBL GX608C 6.5" on all four corners with a Kicker 10" enclosed sub in the rear (all from Best Buy). The system sounds pretty good, but is ultimately limited by the head unit. The tweeter location in the rear doors really helps to increase the mids and lows even while sitting in the...
The crossovers are matched to your speakers. The cutoff points on the factory speakers are not the same as newer aftermarket speakers.
On my '03 I used external crossovers all the way around and it sounds proper. On my'05 I did not use the external crossovers provided up front and it does not...
Below are some quick pics I took on the way home last night. The pictures don't do the light output any justice.
Low Beam only...
Low Beam/Fogs
Low Beam/Fogs/High Beam
Low Beam/Fogs/High Beam/Rigid Spotlight
Rigid Spotlight...
They are pricey, but very badass! It is amazing how far these can throw light in a straight line which is perfect for my setup. My HID lows, LED highs, and LED fogs take care of everything up close, and the Rigid's take that intensity within your field of view and casts it further than you can...
My OME torsion bars were similar - I had to crank the driver's side quite a bit more.
Anytime I adjust my torsion bars, I get a 22mm and a 24mm wrench and loosen the lower control arm bolts. This will allow the bushings in the lca to rotate freely until final ride height is reached. Then, I...
Check my post above with the updated pic. I was incorrect - went out and double checked. The logo should be facing forward which makes the shorter side where the bolt head is located, not on the chassis side.
The lower pic in my post above is the incorrect installation. I had the same...
It goes on both ways. However, the proper way is for the shorter side to bolt onto the chassis to eliminate any interference with the mount when the shock articulates.