Just when you think you’re done...
I had it all set up right then torqued the bearing cap bolts down and it made the backlash virtually disappear... makes sense I guess given that they’re essentially pushing the bearing cups and assembly down more.
The FSM doesn’t address how to correct for this neat occurrence.
I asked and Zuk helpfully responded(thanks) to a question and says that he torques the bolts down before adjusting for backlash, so he hasn’t seen this. I just can’t imagine the force necessary to move the adjusting nuts with the cups fully torqued down.
Any ideas?
I had it all set up right then torqued the bearing cap bolts down and it made the backlash virtually disappear... makes sense I guess given that they’re essentially pushing the bearing cups and assembly down more.
The FSM doesn’t address how to correct for this neat occurrence.
I asked and Zuk helpfully responded(thanks) to a question and says that he torques the bolts down before adjusting for backlash, so he hasn’t seen this. I just can’t imagine the force necessary to move the adjusting nuts with the cups fully torqued down.
Any ideas?