Recent content by teejnut

That's a lot of solar! What size battery are you running?

Where would you lift from? Any nifty mount ideas?

Would love to hear your thoughts and feedback on it once you have it built and tried it out!

I've always wanted to try this but can't weld Tauler Jack Kit - https://brennans-garage.com/collections/bee-safe-recovery-gear/products/tauler-jack-kit What are people's thought about using the new 1.5T Badland or ProEagle jack? It's smaller/lighter then the 3T. Would it be "fine" lifting a...

Selling a used set of Trail Tailor 200-series rear shock guards. I no longer need these since I changed my setup and cannot use them. They were $210 + shipping + tax back in 12/2021. Looking to get $100 shipped via USPS Priority Mail. I'm in Monrovia, CA so if you're local can meet up as well.

Sorry been out on vacation. Sending you a PM now...

Have a quick mount solution to remove or leaving it on? I think I’ve seen you around, I’m in the grey LX in Monrovia.

Bump!

Talked to Dissent and switched to conical lug nuts and that solved my issue!

Another bump. Open to offers too!

I've reach out to Dissent already, but anyone have issues with the tire carrier lug pattern not lining up? With a stock wheel and lug nuts I can get 2 lug nuts on. With aftermarket wheels and extended shank Gorilla lug nuts I can only get one lug nut on. The studs are just off by a 1-2mm, not...

Weekend bump and open to offers!

Bump! Open to offers too!

Bump and price drop. It's taking up space and would like to get rid of it already!

The original intent when I purchased the RLC was to just run the bumper with no swingouts which I did and keep the spare (34s) underneath. My previous 80 had dual 4x4labs swingouts and it does add steps just to get into the back. So I was happy with the RLC usage in this regard. I had no issues...