Bringing back the poverty pack. Just got old hundies back from paint and body. I guess I'm committed now. Need new fogs and a roof rack delete/refurb asap!
Hi All,
I have had a persistent issue for the last year with the transmission in my 2000 LX470 losing 4th gear/OD while driving. Initially, I went through the most common fixes: checking/replacing the transmission sensors, wheel speed (ABS)...
Most of these connectors have a 5-digit number on them. Look at the old/current connector for the 5 digits. Add '90980' before the 5 digits and that's your part number. This works for most connectors.
Picture is just an example - not the...
Same experience here. Not a single noise, going on 5 years with an Eaton. I chose it so I could run fewer and smaller things to the front axle and not have to plumb all the way to the other side of my truck where the compressor lives.
Mine...
Recently picked up a Covercraft for mine, and another for the wife's car after a similar question and a few recommendations from folks that live in Arizona. They've been outstanding. Previously had Weathertech, which got tossed when some of the...
NSXs have always been my favorite. I may get one one day. Until then, cruisers are my questionable financial decisions. Well, NSX or GTR. Either one would scratch my childhood itch.
Mark your calendars and join us September 6th at the Land Cruiser Heritage Museum in SLC, Utah. Full details here: Land Cruiser Heritage Museum - CruiserFest - https://landcruiserhm.com/events/cruiser-fest
Added mud flaps to the cruiser company bumper. The fill the gaps in the body work in the fender. nicely
I recommend the Rokblokz universal truck mud flaps - original size. They come as a set of 4 and would probably work well on the front too...
I have the Bump-It Offroad trilogy. They are HEAVY and have taken some huge hits which is obviously a good thing, but the weight makes it hard to get them off and back on when needing to get to something they cover. My suggestion is sort of a...
Same, but I had the full set of Slee steel plates. There was no change to mileage numbers whether they were on or off. I presume a difference in acceleration or braking, but it was never noticeable.
Can't run the front or mid plate anymore, but...
Finally got the new hood swapped over after getting it blasted and painted, went with the cascadia solar panel as a blackout/battery tender. New moldings, bumpers, wiper plumbing, etc. Very happy with the switch to a mist type nozzle vs. the oem...
3d printed a sleeve for my swing arm latch so that it can accept standard bike grips. The longer length of this makes things so much easier and prevents me from slamming my hands into the locking pin.
Keep it up with the beans and rice, go straight to the MRAs 😂.
No experience on those specific coils, but have loved the dual rate coils they offer. Mine are CVT-485VT I think.