Tommy Shumpert

Not to mention how beautiful it is. Really a fantastic looking 40

We have power steering 🤓 These kits are absolute no brainers for later model 40s with the key on the column.

After lunch while listening to Arch Manning choke I am getting this engine bay built back Most of the valves were close but one was way way loose. I think this thing will cook off much quieter than when it arrived. DUI and Livewires in...

Banff and Lake Luis is beautiful. We love going there.

I'm back. Took Red up to the Canadian Rockies. Fantastic time with my gal and really loved Alberta. Super nice people. Great food. Superb sights.

Anyone know if these will fit without cutting my quarters?

Slowly but surely 😵‍💫

I should have done that on mine… hopefully no issues. Looking good!

Starting on the transmission and transfer case today. I'm going to replace the speedometer housing on the transfer case with a upgraded unit from Georg at Valley hybrid. He modifies an existing OEM housing with dual seals to keep the oil where...

Got the top and the bezel painted.

Had some things I needed to tighten up on the suspension. Steering was pretty sloppy. Couple of tie-rod bolts were loose.😡 Right knuckle also needed a little tightening too. Working on the hood, last big piece of the puzzle. Doors and 1/2 doors...

Making some good progress over the last week. Got the transmission installed. Seems there are some opinions about when to install this (while the motor is out or after the motor is in). Seems like it would be way easier to install while the...

Ok. That's done. Header is mocked up so the wizard can reroute the exhaust above the skid plate and add the cat

3rd member swaps *tech tip* If you are swapping Land Cruiser 3rds from a vehicle that has locking hubs, use the front differential in the rear of the receiving vehicle and the rear to the front. Why? If the hubs are not locked all the front...

There is a rattle in the passenger door I'm going to have to get yall to help me fix. You can hear it in the video. After I got back from the ride I put it up on the rack and tore into it. First job will be swapping the 4.11s fit 3.70s...

Thanks for the update!!

Happy to report we are running like a top! Fixed the ground cable from battery to block. Scratched the paint off block and re made the end connection. It was a little loose. It still ran like crap after I did that. I had posted my data on the...

Take off the paint under the cable on the block.

Holley says I am having a voltage issue. No interference or issues with sniper. I have a new battery and a new alternator. I also built grounds and power cables. Measuring across the battery while running it only shows 12.5V. When I measure pos...

Looks like the PCV was clogged. I had another and replaced it. Seems to be easier to adjust now. I am still having this issue of it failing out at high RPM. After about 3500 or so. They say to keep the wire away from plug wires and other wires...

I dont have one.

All holes are plugged, I will check PCV this afternoon. Thanks for the help!! Much appreciated.

If I spray carb cleaner all over the base and no change, could it be somewhere else? Maybe at HEI connection

Can someone please help me on this? I am at my last straw. The wire running to the HEI for tach is not attached to anything, single wire. So no interference, I have the 12V pink wire running to the fuse box. Red and black straight to battery. I...

Money shots 🙌🙌🙌