I'm regularly getting water inside my camshaft position sensor connection. I've dried it out multiple times and the last time I decided to smother the outside of the connector with Vaseline. I drove through a fair amount of deep water today (I'm sure the connection was under water for awhile) and it got lots of water inside regardless of the Vaseline (it was worth a shot). Any ideas on how I can make this water tight? Can I replace the connections if the seal is gone? If so, where can i get a new connector (both male and female sides)?
I'm open to any tricks. It should be able to be submerged for some time without water getting inside IMO.
I'm open to any tricks. It should be able to be submerged for some time without water getting inside IMO.