dannyvp
SILVER Star
I just reassembled my head, gasket and cooling system on the truck.
When I put my carb back on (Fuji carb) it will not time out with the lean drop method. The idle speed screw will adjust the RPM, but the fuel mix screw will NOT adjust the RPM’s.
I check the site glass and the fuel is all the way at the tip top of the glass.
This is a new carb. Less than couple hundred miles on it.
The vacuum is around 18-20.
suggestions on next steps?
When I put my carb back on (Fuji carb) it will not time out with the lean drop method. The idle speed screw will adjust the RPM, but the fuel mix screw will NOT adjust the RPM’s.
I check the site glass and the fuel is all the way at the tip top of the glass.
This is a new carb. Less than couple hundred miles on it.
The vacuum is around 18-20.
suggestions on next steps?