I am a new owner of a 1989 FJ62 Land Cruiser. As I dive in and research these rigs I am a bit overwhelmed. I want to run 315 75r16 sized tires so basically a 35” tire; running 33’s is too vanilla! So how do I fit them under my rig is the logical next question...?
Through my research, in older threads circa 2010. I have found a few ways to do this, but coils is the dream. So how would you guys approach this? What are guys currently doing to their rigs now that it is 2018
With a budget of around $4,000 and limited access to welders what are my best options?
— Spring Over Axle
— 80 series chassis swap
— Custom coil setup mimicking 80 series on my 60 series
— Go the route of 4inch OME kit from Man-a-Fre
Through my research, in older threads circa 2010. I have found a few ways to do this, but coils is the dream. So how would you guys approach this? What are guys currently doing to their rigs now that it is 2018
With a budget of around $4,000 and limited access to welders what are my best options?
— Spring Over Axle
— 80 series chassis swap
— Custom coil setup mimicking 80 series on my 60 series
— Go the route of 4inch OME kit from Man-a-Fre