Hi guys,
I am a newby considering the purchase of a rig described this way:
1989 FJ62 fuel injected automatic overdrive inline 6, 230K. Upgrades in the last 5 years:
- 2.5 in belton suspension lift
- rebuilt transfer case which include McNamara upgrade 30 spline gear
- New bf Goodrich 33/10.5
- rebuilt front end all bearings and gaskets
- rebuilt rear diff
- throttle position
- idle control motor (sensor?)
- K&N filter
- new fuel pump and tank flush
- new exhaust and catalitic converter
Asking CA$9000
Because I am not much of a mechanic (and I do not have a place where I can work on a truck anyway) it seems ideal that a lot of the overhaul work has already been done. I talked to the current owner but I have not seen the truck yet (a few hours away). I am told that there is only a couple of minor rust spots (bottom of one door and one rear fender) and that there is an oil leak on back of the engine (main rear seal??). Price seems high for an 18yo truck but then again, not too many of those up here in Canada. What do you guys think about some of these components above and what likely still needs to be done in the near future?
There is so much knowledge on this board, your thoughts will be much appreciated.
Cheers!
I am a newby considering the purchase of a rig described this way:
1989 FJ62 fuel injected automatic overdrive inline 6, 230K. Upgrades in the last 5 years:
- 2.5 in belton suspension lift
- rebuilt transfer case which include McNamara upgrade 30 spline gear
- New bf Goodrich 33/10.5
- rebuilt front end all bearings and gaskets
- rebuilt rear diff
- throttle position
- idle control motor (sensor?)
- K&N filter
- new fuel pump and tank flush
- new exhaust and catalitic converter
Asking CA$9000
Because I am not much of a mechanic (and I do not have a place where I can work on a truck anyway) it seems ideal that a lot of the overhaul work has already been done. I talked to the current owner but I have not seen the truck yet (a few hours away). I am told that there is only a couple of minor rust spots (bottom of one door and one rear fender) and that there is an oil leak on back of the engine (main rear seal??). Price seems high for an 18yo truck but then again, not too many of those up here in Canada. What do you guys think about some of these components above and what likely still needs to be done in the near future?
There is so much knowledge on this board, your thoughts will be much appreciated.
Cheers!