ARCHIVE Yesterday at 4:55 PM Thread starter Add bookmark #5 Check out my ORK, Off Road Kit for the TRAC Tire Jack! This kit takes the TRAC Tire Jack and conve

[Tirettools]

• Yesterday at 4:55 PM

• Thread starter
• 
  
• Add bookmark
• #5

Check out my ORK, Off Road Kit for the TRAC Tire Jack!
This kit takes the TRAC Tire Jack and converts it to off road use, The steel roller is replaced by an axle and 2 -4 inch rubber wheels, The handle is attached by drilling three holes in the TRAC Jack, The handle is 16" long 1 1/4 x 1 1/4 steel tubing with a shrink wrapped covering. The wheels are rated at 350 lbs each!
When done using, simply remove one bolt and securing knob, rotate handle 180 degrees, insert bolt and securing knob and its ready to be stowed or clamped to roll bars, molle panels or many other points of attachment in many vehicles. I have a limited run of 30 units ready to be shipped, Go to tiretoolproducts.com to order.

Thanks,
Dave Teal