Why wont it start?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

The battery reads 12.6 with a multimeter,
Any suggestions on any particular fuses I should check first before I replace the starter.
Lets see a picture of the terminal you just installed.

Can you confirm dash board/ lights / etc. all work?


Then you turn the key and nothing happens?



I don't have much experience with the starter circuit but I would think if you have a multimeter you could probably probe around at the starter relay or something to confirm it's getting power before diving into a starter replacement
 
The battery reads 12.6 with a multimeter,
Any suggestions on any particular fuses I should check first before I replace the starter.
Pick any fuse inside the fuse box and check the voltage between ground terminal on the battery and a terminal on that fuse. If this shows less than 12.6 V, the issue is further up. Report back.
 
tempImagej7O3eG.jpg
 
Still, get one click when I turn the key to start, I pulled the 30 amp relay, for the starter, and got no click when I tried to start it.
 
Still, get one click when I turn the key to start, I pulled the 30 amp relay, for the starter, and got no click when I tried to start it.
Can you confirm dash board lights up and everything is getting power with key on
 
Yes it all sounds and looks normal right up until the 1 click.I tried to post a video of me trying to start it but I cant figure out how to do it
 
Get an OEM terminal.
 

Users who are viewing this thread

Back
Top Bottom