where do i get a crate 350? (1 Viewer)

[jamminfj]

any thoughts where i can?

 

[dylan]

through your local chevy dealers parts department.

 

[Poser]

Try these guys for mail order...otherwise, get to know a dealer really well, and they may be close on the price, including shipping..


http://www.paceparts.com/product.asp?0=239&1=241&3=917


Good luck!

-Steve

 

[TonkaC]

some parts store can get edelbrock crate engines along with oe replacement engines.

 

[fjcruiser]

I know its not the question that you orginally asked, but, have you considered other options?
I have heard that some or all of the gm crate motors are assembled in Mexico, or some place other than the US (not positive).
I would look into having a machine shop or engine builder do the job. They will set the engine up the way you want it (torque, hp, etc.)
Just a thought.

 

[skiakhokie]

I don't know if anyone has used these guys, but I was considering them when I was going to replace my 2f with a 350. I don't know much about them, just thought you might want to check it out.

http://www.chevy-350-engines.com/

I talked to them and they said they could build any 350 with whatever you wanted rods, rings, pistons.... good luck

 

[nocents]

eBay motors has a few "crate 350" too.

 

[lagwagon]

Look in Hot Rod type magazines and my local NAPA carries a magazine called Drive which has adds for GM dealers competing for lowest prices on crate motors.

 

[gater75]

Sallee Chevrolet out of Milton-Freewater Oregon(NE corner) sells them, they are very reaasonably priced, and have a really nice website also. this is where I got my crate motor. They were at least $500 less than any of the other Gm or Chevy dealers in the areea.
No affiliation, just a satisfied customer.

 

[cruise4070]

Check for the nearest Jasper dealer near you.
I have a 350 300hp with RV(heavier cam) in the 55 and its a nice setup.
They also have a good warranty.
-
http://www.jasperengines.com/