Wheel Bearings, What all do I need?

[DuManchu]

Ok, did a search and I'm still a bit cloudy.

Went to Autozone to get Timken FR wheel bearings, here's what I got.

2x JLM104948 - Inner Bearing
2x SET47 - Outer Bearing and Race

After some searching, it looks like I also need the inner races.
Is that correct?

I also got Moly Fortified MP Grease for the Birfs and trunion bearings and Non-moly MP Grease for the wheel bearings.

Thanks,
-Andrew

 

[ed97fzj80]

Are you doing a birf job too? If so, Cruiserdan's rebuild kit will have everything else you'll need. If not, you'll need the drive flange gaskets and new circlips, as well as an 8 x 1.25 bolt for setting the circlips back in place. Oh, and circlip pliers -- don't go into a hub without them. You'll need a lithium high temperature grease for the wheel bearings. Sorry, don't know about the inner race.

 

[DuManchu]

Yeah, I have the FR axle kit from Dan, but I ordered it without wheel bearings since its cheaper to buy the Timken bearings at AutoZone.

The MP grease I have for the wheel bearings is for up to 400F, same with the Moly.

-Andrew

 

[Beowulf]

You may need a dust seal for the inner wheel bearing. Check the list that Dan supplied you.

You will need races for the inner and outer.

-B-