Does anybody know what this (looks like a sensor) is for? I just found it hanging around in my engine bay by the ac compressor
What is this (2 Viewers)
- Thread starter krumby
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Hello,
It looks like an air temperature sensor for the EFI system.
You are lucky. It appears to be intact. They have a tendency to fall tip first into hot things like the exhaust manifold, melting in the process.
There should be a port in the intake duct where it fits in.
Juan
It looks like an air temperature sensor for the EFI system.
You are lucky. It appears to be intact. They have a tendency to fall tip first into hot things like the exhaust manifold, melting in the process.
There should be a port in the intake duct where it fits in.
Juan
- Thread starter
- #3
I can’t seem to find the place where it goes ??? I don’t see a hole anywhere within the wires reach
Is this the IAT location for your engine
Hello,
Check the intake duct, namely the rubber section between the air filter and the intake manifold. There should be a port there. Sometimes it is near the resonator.
The sensor needs a grommet to fit in the port. It is possible that you may have to order or fabricate one.
Juan
Check the intake duct, namely the rubber section between the air filter and the intake manifold. There should be a port there. Sometimes it is near the resonator.
The sensor needs a grommet to fit in the port. It is possible that you may have to order or fabricate one.
Juan
