Last night I noticed that when I applied pressure to the brake pedal the brake lights came on strong and as I continued to press the pedal they went off. If I lightly touch the pedal they work great. It seems to me this is a defective brake light switch (BLS) but I have never heard of this before. Could this be a BLS adjustment issue? I don't think I have been driving with this out of adjustment for years, but who knows, maybe I have? I drove the 40 from Denver to Moab and back and my wife, who was following behind me, did not notice this behavior so I think it's new.
I find it a little hard to believe that the BLS went out of adjustment. Has anyone seen this before? Should I just put on a knew BLS? Maybe pull out the existing one and test the function with a volt/ohm meter?
Any advice would be appreciated.
I find it a little hard to believe that the BLS went out of adjustment. Has anyone seen this before? Should I just put on a knew BLS? Maybe pull out the existing one and test the function with a volt/ohm meter?
Any advice would be appreciated.
