So I’ve been running a lot of electrical wires through the PS firewall grommet. And once done the plan is to put some silicone or liquid tape and tape that sealed the best I can.
Recently with the rain in CA I parked my car in an inclined driveway over night and found a puddle in the floor mats this AM.
I checked the area…grommet has some drops on and I think some rain is getting in and dropping on the wires and the water is just traveling down the wire into the grommet.
But I also spied this little vent that had a pool of water around it. Anyone know where this goes? The tic tac toe looking vent in the left side. Seems to go behind the firewall to behind the fender. I didn’t get to poke around much cuz I’m at work but annoying. And I want to nip this in the bud before it causes any corrosion.
Recently with the rain in CA I parked my car in an inclined driveway over night and found a puddle in the floor mats this AM.
I checked the area…grommet has some drops on and I think some rain is getting in and dropping on the wires and the water is just traveling down the wire into the grommet.
But I also spied this little vent that had a pool of water around it. Anyone know where this goes? The tic tac toe looking vent in the left side. Seems to go behind the firewall to behind the fender. I didn’t get to poke around much cuz I’m at work but annoying. And I want to nip this in the bud before it causes any corrosion.