I am rebuilding my spare 3-speed transfer case. There is some
wear of the "dog teeth" on the high speed gear. The clutch
sleeve mates to these teeth and then onto the output shaft.
My question is: how much wear is too much? I can't find anything
in Haynes or the factory service manual to tell me what the wear
limits are. The movement is less than one degree of rotatation, and
the dog teeth are only worn on one edge. Sorry if the words don't
make sense -- I tried a photo but it did not turn out too well.
wear of the "dog teeth" on the high speed gear. The clutch
sleeve mates to these teeth and then onto the output shaft.
My question is: how much wear is too much? I can't find anything
in Haynes or the factory service manual to tell me what the wear
limits are. The movement is less than one degree of rotatation, and
the dog teeth are only worn on one edge. Sorry if the words don't
make sense -- I tried a photo but it did not turn out too well.